Our Models

General Info about our spray booths

MAIN CABIN

 

Side walls are made of galvanized 1mm  steel sheets, with 40 mm glasswool insulation. It helps  to prevent heat loss and makes our spray booths much more economical and efficient. Additionally it allows for quieter operation and reduces noise pollution.  In order to provide an ergonomic view and longer life, outside surface of the panels are painted with durable static powder paint.

Our products have the illumination system which had been designed in order to optimise the color control during the painting phase.

Firat spray booths have a hanger system with rails hanged up to the ceiling, which allow to hang parts, which are being painted or drying beside the automobile.

Ceiling is the section which provides the excellent air flow. The air is driven from outside, filtered (and heated in the bake phase) and blow inside the booth. Ceiling consists of sheet panels with special insulation and high performance and durable filters made of non-flammable material.

There are four leaf doors at front of the booth for vehicle entrance and single door system for personel entry and exit. Door items have observation windows made of safety glass. All the doors are 55 mm deep and insulated with 55 mm glasswool.

 

AIR MAKE-UP UNIT

 

This unit supplies the filtered fresh air into the booth and throws the used air outside during painting phase. On the other hand, during drying it heats the air up to 60 °C , mix used air with fresh air in proportion of 10% (through the multi damper) and circulates it after re-heating. This recycling of the already warmed air is very effective and energy efficient. It can speed up the process and safes lots of energy.

The air is heated by a diesel burner having a capacity of 150.000 kcal/h and an exchanger made of stainless steel sheet. We can supply a direct or indirect gas burner. Start up and rising the air temperature up to 60 °C takes approximately 15 minutes, depending on outside weather conditions.

Delivery of the heated or not heated air into the booth or circulation of it is provided by two industrial type fans, each having the capacity of 18.000 m³ / h. In this unit air is delivered to the booth after filtered by a pre-filter. Additionally output air is controlled by a damper in the output air channel.

ELECTRICAL SYSTEM
 
Electric and Command Panel

 

Panel in which the motors and devices in the enclosure of the proposal are operated and controlled from a central point in order to provide them to fulfill their functions.

Panel is made of GALVANIZED sheet and steel profiles, which are bump resistant, completely covered, water proof and damp proof.

 Panel shall include all switches and fuses necessary for motors and electrical devices, where appropriate signal lamps, thermic relay, contactor and clemences.

 

Wiring

 

Command and control connections from electric panel to motors and other electrical devices shall be done with heatproof cables. Electric lines shall be placed on a basis so that formation and replacement is easy.

Ready to operate devices: 380 V.50 Hz. Voltage of control devices is 24 volt.

FUNCTION

 

Provides auto painting and drying operation in accordance with health and security norms. Conformity to TSEK quality factor and conformity values is determined with Quality conformity certificate no. 35 -14.02/1557 of 2001. In accordance with the Law no. 132 and TSE legislation, “Production Compliance Certificate “ had been consigned. Analysis result executed by TUBITAK ENERGY SYSTEMS and ENVIRONMENT RESEARCH INSTITUTE ENVIRONMENT DIVISION, approved through the report no. B.02.1BAK.5.01.52.00/2015 and Project no. 51H2402, that FIRAT Auto Painting Spray Booths does not constitute any environment pollution.

 

This site was designed with the
.com
website builder. Create your website today.
Start Now